Team fishseekers: Corkscrew.

Iwe had alot of questions from all over about how i make my corkscrew rigs, thats why i will make this post in english. This is something that people have been doing for a long time but noone has really posted anything about it untill last month when Mr.Claesklassessons did just that. I started doing theese last year as a complement to the soft4play offsethook. We often fished the coast in really shallow waters at the time and i wanted to make all my rubber baits fish really shallow. The success at that time were slim, but this year its improved.
You will need two pliers, and one screwdriver. The wire i use is about 0.8mm thick but you can use whatever you feel confortable with. I want it to hold if a big lady decides to take the bait.
Take the wire and make a single loop


Take the plier and wrap the wire around itself about two laps.


Cut off the end…

Now here’s where it gets a bit tricky, however after a few screws, it’s really easy. Place the screwdriver like the picture shows,

Then you put one of the pliers as this picture shows, you need a firm grip to hold it together,

begin to wrap the wire around the screwdriver…

About ten times is enough,

before you remove the screw, leave it like the picture shows to adjust the loop so it’s centered.


Remove the screw and take two pliers to pull apart the screw as shown below,



Tadaaaaa!


Läs mer...

(Detta inlägg har postats automatiskt)